This is from an 07 Liberty with 108k miles on it. It will fit any Liberty or Dodge Nitro that has a 3.7 engine. It technically would fit any Chrysler vehicle with a 3.7 engine: commander, grand cherokee, and dodge dakota. However I'm unsure if the shifter will be in the right place. The jeep was 2wd but this will easily adapt to 4wd, just unbolt and remove the yoke on the output shaft and you're good.
The t case bolts right up. The pressure plate and clutch were recently replaced. LUK can easily be read on them, which, I believe is an upgrade over OEM. It comes with trans, shifter, shifter boot, flywheel, pressure plate, clutch, starter plate, trans mount and plate that bolts to the cross member, and all the bolts. This is a Benz designed and german manufactured transmission.
They are very strong yet very light. All the other stuff will come in another package. Message me with any questions.The item "6 SPEED MANUAL TRANSMISSION CONVERSION KIT NSG370 JEEP LIBERTY 3.7 DODGE NITRO" is in sale since Thursday, October 22, 2020. This item is in the category "eBay Motors\Parts & Accessories\Car & Truck Parts\Transmission & Drivetrain\Manual Transmissions & Parts\Complete Manual Transmissions". The seller is "jdc7451" and is located in Fort Wayne, Indiana. This item can be shipped to United States.